The MillerTech 36V 105Ah (Sun Up – Sun Down) Sport Series Lithium Battery, model 36105-BT, is a LiFePO4 (lithium iron phosphate) deep cycle battery built to power 36-volt trolling motors from the first cast to the last. It replaces the traditional bank of three 12V lead-acid or AGM batteries wired in series with a single 68.2 lb battery, removing the jumper cables and the uneven charging that comes with three separate batteries.
Size and footprint: 13.5" L x 9.6" W x 10.5" H in a custom case. That is about half the floor space of three Group 31 batteries side by side, but about 1" taller than a Group 31, so check the height clearance under your deck or hatch lid before ordering.
With 105Ah and 4032Wh of stored energy, it holds roughly twice the capacity of a typical 36V 50Ah lithium battery. That extra capacity is for anglers who spend long days on Spot-Lock in wind and current, run bigger boats such as bay boats, center consoles, and pontoons, or fish back-to-back days without access to shore power. The flat LiFePO4 voltage curve keeps your trolling motor at consistent speed through the day instead of fading as the battery drains.
Built-in Bluetooth connects to the MillerTech App so you can see state of charge and power draw from your phone. A battery management system (BMS) with low-temperature charging protection, a custom waterproof case with dual stainless steel air vents, pure brass terminals, and an integrated carry handle round out the build. The battery is backed by a 10-year manufacturer warranty from MillerTech.
Built for: 36V Minn Kota, Garmin, Lowrance, and MotorGuide trolling motors on bass boats, multi-species boats, bay boats, center consoles, and pontoons. MillerTech also lists the 36105-BT for 36V golf carts and other 36V LiFePO4 systems.
Key Features
-
105Ah / 4032Wh in one battery: Enough stored energy for full days of trolling motor use, including windy days on Spot-Lock, without carrying three separate batteries.
-
Compact 13.5" x 9.6" footprint: One case takes about half the floor space of a three-battery Group 31 bank, freeing room in the battery compartment. Height is 10.5".
-
One battery replaces three: Takes the place of three 12V lead-acid or AGM batteries wired in series. Fewer cables, fewer connections, and one battery to charge.
-
Flat LiFePO4 discharge curve: Voltage stays steady deep into the charge, so your motor keeps its speed and thrust late in the day.
-
Bluetooth monitoring with the MillerTech App: Check state of charge and real-time power draw from your phone, so you know what is left before you head to the next spot.
-
150A continuous / 300A peak (5 seconds): Well above the maximum draw of 36V trolling motors such as the Minn Kota 112 lb. models (52A max per Minn Kota) and the Garmin Force at 36V (54A at full throttle per Garmin).
-
BMS with low-temperature charging protection: The battery management system protects the cells and blocks charging when temperatures are too cold for safe lithium charging.
-
Marine-ready construction: Custom waterproof case, dual stainless steel air vents, pure brass terminals, and an integrated carry handle.
-
Prismatic LiFePO4 cells, 98% efficiency, no memory effect: Charge whenever it is convenient; partial charges do not reduce capacity.
-
10-year manufacturer warranty: Backed directly by MillerTech.
Compatibility, Size & Run Time
The 36105-BT is designed for 36-volt trolling motors. It is not for 12V or 24V motors. Dual-voltage motors such as the Minn Kota QUEST series and the Garmin Force must be set up for 36V operation.
Compatible 36V trolling motors include:
- Minn Kota Ultrex 112, Ultrex QUEST (36V), Terrova 112, Riptide Terrova (36V), Ulterra 112, Ulterra QUEST (36V), Riptide Instinct QUEST (36V), and Fortrex 112
- Garmin Force (36V setup)
- Lowrance Ghost (36V setup)
- MotorGuide Xi5 and Tour series (36V models)
Commonly used on:
- Bass boats Ranger, Skeeter, Nitro, Bass Cat, Phoenix, Triton, Tracker
- Walleye and multi-species boats Lund, Crestliner, Warrior, Alumacraft
- Bay boats, center consoles, Carolina skiffs, and pontoons running a 36V bow-mount motor
- Boats where anglers want multi-day runtime from a single battery
Size & fit. The 36105-BT uses a custom case that does not match a standard BCI group size. Compare it with the batteries you are replacing:
| Battery setup |
Length |
Width |
Height |
Approx. floor space |
| MillerTech 36V 105Ah (36105-BT) |
13.5" |
9.6" |
10.5" |
About 130 sq in |
| One Group 31 battery (typical) |
About 12.9" |
About 6.8" |
About 9.4" |
About 88 sq in |
| Three Group 31 batteries side by side (36V bank) |
About 12.9" |
About 20.4" |
About 9.4" |
About 263 sq in |
Group 31 dimensions vary slightly by manufacturer; figures shown are typical. Floor space does not include spacing between batteries or tray flanges.
Before ordering, check three things: the compartment is at least 13.5" long and 9.6" wide, there is at least 10.5" of height clearance plus room for cable connections at the terminals, and the battery can be strapped down securely. Standard Group 24, 27, 31, or 34 trays will not fit; use the MillerTech Battery Tray for 36V 105Ah and 12V 300Ah Batteries.
Estimated run time. Actual run time depends on throttle setting, wind, current, boat weight, and how much you use Spot-Lock or anchor mode. The estimates below assume about 100Ah of usable capacity and use the current-draw figures Garmin publishes for the Force trolling motor at 36V. Minn Kota 112 lb. motors have a similar maximum draw (52A).
| How you are fishing |
Approx. throttle |
Avg. current draw |
Estimated run time |
| Slow trolling, calm water, light Spot-Lock |
30–40% |
4–6A |
16–25 hours |
| Typical fishing day, mixed speeds |
About 50% |
About 10A |
About 10 hours |
| Windy day, frequent Spot-Lock |
60–70% |
15–21A |
5–6.5 hours |
| Heavy wind or current |
About 80% |
About 29A |
About 3.5 hours |
| Continuous full throttle |
100% |
52–54A |
About 1.9 hours |
Estimates only. Most fishing days mix speeds, so average draw typically lands between 10A and 20A. Use the MillerTech App to track real state of charge on the water.
Wiring note: When you switch from three batteries to one, the series jumper cables are removed and only the positive and negative leads run to the trolling motor. Keep a circuit breaker on the positive lead. Minn Kota specifies a 60-amp breaker for its 112 lb. 36V motors and for QUEST models at 36V, with wire size based on run length; follow your motor manufacturer's wiring guide.
Electronics note: This is a 36-volt battery for your trolling motor. Fish finders, live sonar, and other 12V electronics should run from a separate 12V battery, and your cranking battery stays on its own circuit.
Other 36V uses: MillerTech also lists this battery for 36V golf carts, RV, off-grid, and other 36V LiFePO4 systems. For golf carts, confirm your controller's current draw fits the 150A continuous and 300A peak (5 seconds) rating before installing.
Charging & Compatible Chargers
Charge with a 36V lithium (LiFePO4) charger only. Lead-acid and AGM chargers will not charge this battery correctly. Minn Kota on-board chargers cannot be used: Minn Kota states its chargers are not compatible with single 24V and 36V lithium batteries. If you are moving from three lead-acid batteries on a 3-bank Minn Kota charger, plan on replacing the charger.
| Charger |
Model |
36V Output |
Best For |
| MillerTech 36V 15A On-Board |
3615M |
15A / 43.5V, 110V AC input, IP65 |
Overnight dock or garage charging |
| MillerTech 36V 30A On-Board |
3630M |
30A, 110V AC input, IP65 |
Faster turnaround between trips |
| MillerTech 12V / 36V Dual Bank On-Board |
1215-3615 |
36V 15A plus 12V 15A |
Charging the 36V trolling battery and a 12V battery from one plug-in |
| MillerTech 12V–36V Dark Speed On-The-Run Dual Marine Charger |
— |
Alternator (DC) charging |
Recharging while you run the outboard between spots |
Estimated charge time from empty: about 7 to 8 hours with a 15A charger, or about 3.5 to 4 hours with a 30A charger. From 50% to full, about half of that. Times vary with temperature and charger settings.
Mounting: The 36105-BT uses a custom case measuring 13.5" L x 9.6" W x 10.5" H. It does not match a standard BCI group size and will not fit a Group 24, 27, 31, or 34 tray. The MillerTech Battery Tray for 36V 105Ah and 12V 300Ah Batteries (1/8" aluminum with foam padding) is sized for it.
Specifications
| Model |
36105-BT |
| Chemistry |
LiFePO4 (Lithium Iron Phosphate) |
| Nominal Voltage |
38.4V (36V class) |
| Capacity |
105Ah |
| Energy |
4032Wh |
| Max Charge Voltage |
43.2V |
| Max Charge / Discharge Current |
100A |
| Continuous Discharge |
150A |
| Peak Discharge Current |
300A (5 seconds) |
| Low Cut-off Voltage |
30V |
| Cell Type |
Prismatic |
| Efficiency |
98% |
| Memory Effect |
None |
| Battery Management System (BMS) |
Yes |
| Low-Temp Charging Protection |
Yes |
| Bluetooth Monitoring |
Yes (MillerTech App) |
| Operating Temperature |
-4°F to 140°F |
| Weight |
68.2 lbs |
| Dimensions |
13.5" L x 9.6" W x 10.5" H |
| Case Size |
Custom case (not a standard BCI group size) |
| Construction |
Custom waterproof case, dual stainless steel air vents, pure brass terminals, integrated carry handle |
| Warranty |
10-year manufacturer warranty (MillerTech) |
FAQ