If you run a 24V trolling motor and only have room for one battery, this is the battery built for that problem. The Dakota Lithium 24V 60Ah is a single 24-volt LiFePO4 battery in a Group 24 case that replaces two 12V batteries wired in series, one battery, one slot, 24 volts out.
Dakota Lithium built it for technical skiffs, mid-size bass boats, and 24V trolling motors in smaller rigs, where run time and weight matter most. At 24.9 lbs, it removes the series jumper cable, the two-bank charger, and the mismatched-pair problem that comes with running a lead-acid pair. It also frees up a battery compartment you can use for something else.
Because it's LiFePO4, you get consistent power for all 60 amp hours. Dakota Lithium batteries have a flat voltage curve, which means steady power output as the battery discharges the power output does not dramatically drop off like a similar-sized SLA battery does at the end of the day.
It's rated for 5,000–8,000 recharge cycles (8–10 years at regular use) and backed by Dakota Lithium's 11-year manufacturer defect warranty. Beyond trolling motors, it can be linked in series or parallel for solar energy storage in the home, RV, boat, or off-grid applications, and Dakota Lithium 24V batteries can be used in series for up to 48V systems.
This is a deep cycle battery. It is not designed for engine starting, and it does not have internal heating. Check the Fitment tab before ordering.
Key Features
-
Single-battery 24V design: One battery delivers 24 volts, so there's no series wiring, no jumper cable, and no second battery to match.
Simpler install, fewer connections to corrode or fail.
-
Group 24 case, 24.9 lbs 9.1"L x 6.8"W x 8.66"H in a compact Group 24 footprint.
Drops into a standard Group 24 tray and takes real weight off the bow of a skiff or aluminum boat.
-
1,536 Wh of usable energy 60Ah at 24V rated (26.6V resting).
Full capacity is usable, unlike lead-acid where discharging past 50% damages the battery.
-
Flat voltage curve, Steady power output as the battery discharges.
Your motor holds power at hour six the same as hour one no fade at the end of the day.
-
80A max continuous discharge, 100A max pulse (10 second).
Headroom for the amp draw of a 24V trolling motor under load.
-
5,000 - 8,000 recharge cycles Up to 80% capacity for 5,000 cycles in recommended conditions, versus roughly 500 cycles for a typical SLA.
8 - 10 years at regular use, so the cost per use is a fraction of a lead-acid battery you replace every 2 - 3 seasons.
-
Active BMS protection, Cell balancing, low voltage cutoff, high voltage cutoff, short circuit protection, and high temperature protection.
The battery protects itself, which extends its life.
-
Compatible with onboard charging, Accepts up to 80A max charge current, so it works with a LiFePO4 onboard charger mounted in the boat.
Leave the battery in the boat and plug the boat in no pulling 25 lbs out of the compartment after every trip.
-
M8 bolt terminals, Max torque 15 ft-lbs.
Easy to adapt to ring terminals and standard trolling motor wiring.
-
Series-capable to 48V: Dakota Lithium 24V batteries can be used in series for up to 48V systems.
One battery today, a 48V bank later if your setup changes.
-
Maintenance-free LiFePO4: No watering, no acid, no off-gassing, and it can be mounted in any orientation.
Install it and forget it.
-
11-year warranty: Dakota Lithium's manufacturer defect warranty.
Coverage that outlasts most boats' ownership cycle.
-
Certified and tested: UN 38 certified. Cells are UL1642 certified and tested per IEC62133 standards. Dakota Lithium is ISO 9001:2015 certified.
Meets US and international regulations for air, ground, train, and marine transport.
Fitment
Dakota Lithium recommends this battery for technical skiffs, mid-size bass boats, small boats, skiffs, and kayaks running 24V trolling motors, plus 24V solar energy storage.
Trolling motor sizing - Dakota Lithium's pro staff recommendations:
| Motor Thrust |
Max Amp Draw @ Voltage |
Recommended Battery |
| 70 lb |
42A @ 24V |
24V Single (this battery), or DL 54 x2, or DL+ 60 x2, or DL 100 x2 |
| 80 lb |
56A @ 24V |
DL+ 60 x2, or DL 100 x2, or DL+ 320 x2 |
How much capacity do you need? Dakota Lithium's guidance:
-
60 amp hours is right if you rarely run your motor at max power. A 60Ah battery will give you a full day of run time.
-
Step up to 100Ah or more if you run at max power often, use spot lock often, or regularly fish in heavy current.
-
Step up to 100Ah or more if you have a pontoon boat or a boat holding lots of people.
-
Step up to 100Ah or more if your definition of a fishing day is before sunrise to after sunset.
Recommended applications
- 24V trolling motors on technical skiffs and flats boats
- 24V trolling motors on mid-size bass boats
- Small aluminum boats, jon boats, and kayaks
- Deep cycle marine applications where you need power for a long time
- Solar energy storage in the home, RV, boat, or off-grid applications
- 24V house power, linked in series or parallel for larger banks
- 48V systems, using two batteries in series
This battery is not for:
-
Engine starting. Dakota Lithium's standard deep cycle packs do not have cranking ability and cannot be used for starting motors. For engine starting, look at the Dakota Lithium DL+ Dual Purpose line or the LTO Automotive Cranking battery.
-
Cold-weather charging. This model does not have internal heating. Avoid charging below 32°F.
-
Submersion. The case is rugged and waterproof, but enough water can conduct electricity between the terminals, do not submerse the battery.
Specifications
| Brand |
Dakota Lithium |
| Model |
DL 24V 60Ah |
| Chemistry |
Lithium Iron Phosphate (LiFePO4) |
| Voltage |
24V rated (26.6V resting voltage) |
| Capacity |
60 ampere hours (Ah) |
| Energy |
1,536 Wh |
| Max Continuous Discharge |
80A |
| Max Pulse Discharge |
100A (10 second pulse) |
| Recommended Charge Current |
12A (0.2C) |
| Max Charge Current |
80A |
| Charge Voltage |
28.8V recommended, 60V max |
| Cycle Life |
5,000 – 8,000 recharge cycles (8–10 years at regular use). Up to 80% capacity for 5,000 cycles in recommended conditions. |
| Weight |
24.9 lbs (11.3 kg) 70% lighter than an SLA battery |
| Dimensions |
9.1"L x 6.8"W x 8.66"H (230mm x 174mm x 215mm - 210mm to top of battery, 215mm to top of terminal) |
| Case Size |
Group 24 |
| Terminals |
M8 bolt size (max torque 15 ft-lbs) |
| Operating Temperature |
-20°F min, +120°F max optimal operating temps. Avoid charging below 32°F. |
| BMS |
Active BMS: cell balancing, low voltage cutoff, high voltage cutoff, short circuit protection, high temperature protection |
| Bluetooth |
Not included |
| Internal Heating |
Not included |
| Engine Starting / Cranking |
No, deep cycle only |
| Series / Parallel |
Can be linked in series or parallel. Series up to 48V systems. |
| Case |
Rugged, waterproof case. Can be mounted in any orientation. Do not submerse. |
| Onboard Charging |
Compatible with LiFePO4 onboard chargers, within the 80A max charge current |
| Recommended Charger |
24V 5A LiFePO4 charger (sold separately) |
| Certifications |
UN 38 certified. Cells UL1642 certified, tested per IEC62133 standards. Meets all US & International regulations for air, ground, train, & marine transport. Dakota Lithium is ISO 9001:2015 certified; select models produced in ISO 14001 certified facilities. |
| Warranty |
11-year manufacturer defect warranty |
FAQs